درباره ما
ASCE - American Society of Civil Engineers: Recent submissions
Now showing items 121-140 of 168
-
ASCE MOP 128
Abstract: PURPOSE
The building security rating system was created to develop construction and operations criteria and a matching rating system to describe the relative security and safety of buildings and building ... -
ASCE 52-10
Abstract: INTRODUCTION
The following standard applies to fiberglass-reinforced plastic (FRP) stacks, that is, those stacks where the primary supporting shell is made of FRP. This standard can be applicable to ... -
ASCE MOP 127
Abstract: INTRODUCTION
The scope of Hydraulics of Wells was designed in a manner so as to familiarize the reader with the subject matter of hydraulics of wells as related to the production of groundwater ... -
ASCE 41140
Abstract: OBJECTIVE
Many different codes and standards are used in the structural and seismic design and assessment of petrochemical facilities. Many of these codes have been developed primarily for use in the ... -
ASCE 56-10/57-10
Abstract: FOREWORD
These guidelines were developed as a joint effort between the American Society of Civil Engineers (ASCE) and the American Water Works Association (AWWA) with technical input from the Water ... -
ASCE 40-03
Abstract: The material presented in this Standard has been prepared in accordance with recognized legal and engineerhg principles. This Standard should not be used without first securing competent advice with respect to its suitability ... -
ASCE 23-97
Abstract: This Specificatìon for Structural Steel Beams with Web Openings supplements the Load and Resistance Factor Design Specification for Structural Steel Buildings of the American Institute of Steel ... -
ASCE 45-05,46-05 AND 47-05
Abstract: The intent of these standard guidelines is to present design guidance for urban stormwater systems. The collection, management, and conveyance of urban surface waters are within the purview of these standard guidelines for ... -
ASCE ANCHORAGE DESIGN
Abstract: OBJECTIVES AND SCOPE
The objective of this committee was to update the previous report, summarizing the State-of-the-Practice for the design of cast-in-place anchor rods, welded anchors, and post-installed ... -
ASCE 3-91/9-91
Abstract: This Standard Practice, including appendices, presents provisions applicable to composite slabs. This Standard Practice is intended as a guide document and not as a mandatory standard practice for:
(a) good construction ... -
ASCE 39-15
Abstract: This document describes a process through which hail suppression operations should be designed, organized, and conducted. The information contained herein is intended to be helpful to those persons wishing to implement ... -
ASCE 40107
Abstract: This proceedings, Groundwater Management, contains papers presented at the International Symposium held in San Antonio Texas, August 14-16,1995. It covers such issues as: 1) Models of remediation systems, 2) groundwater ... -
ASCE 21.3-08
Abstract: This standard has been divided into four parts to expedite the approval and release process as well as to facilitate ease of use. This document constitutes Part 3 of the standard.
Parts 1, 2, and 3 cover a minimum set ... -
ASCE 33-09
Abstract: PURPOSES OF AGREEMENT
1. The Waters of the __________ Basin are affected by local, national, and regional interests, and their planning, conservation, utilization, development, management, and ... -
ASCE IACGE
Abstract: Preface
This Geotechnical Special Publication contains selected technical papers of the 2nd International Conference on Geotechnical and Earthquake Engineering organized by the International Association ... -
ASCE MOP 67
Abstract: Although wind tunnel model testing has gained wide acceptance, it is important to stress that the action of wind in many cases is adequately dealt with in existing building codes. It is therefore important to identify ... -
ASCE 21-13
Abstract: This standard has been combined from four previous parts identifi ed below, to expedite the approval and release process and to facilitate ease of use.
Previous Parts 1, 2, 3, and 4 of ASCE 21-05 and 21-08 cover a ...