JSA JIS B 1054-1

Abstract

This Standard specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10&#176;C to 35 &#176;C. Properties vary at higher or lower temperatures. <br>This Standard applies to bolts, screws and studs <br>- with nominal thread diameter ds39 mm, <br>- of <strong>ISO</strong> general purpose metric threads based on <strong>JIS B 0205-1</strong> with diameters and pitches in accordance with <strong>JIS B 0205-2</strong> and <strong>JIS B 0205-3</strong>, and <br>- of any shape. <br>It does not apply to bolts, screws and studs with special properties, such as weldability. <br>NOTE: The designation system of this Standard can be used for sizes outside the limits given in this clause (e.g. d&gt; 39 mm), provided that all applicable mechanical and physical requirements of the property classes are met. <br>This Standard does not define corrosion or oxidation resistance in particular environments. However, some information on materials for particular environments is given in Annex E. Regarding definitions of corrosion and corrosion resistance, see <strong>ISO 8044</strong>. <br>The aim of this Standard is the classification of corrosion-resistant stainless steel fasteners 1) into property classes. Some materials can be used at temperatures down to -200&#176;C, while some can be used at temperatures up to +800 &#176;C in air. Information on the influence of temperature on mechanical properties is found in Annex F. <br>Note 1) The term "fasteners" is used when bolts, screws and studs are considered all together. <br>Corrosion and oxidation performances and mechanical properties for use at elevated or sub-zero temperatures can be agreed on between the user and the manufacturer in each particular case. Annex G shows how the risk of intergranular corrosion at elevated temperatures depends on the carbon content. <br>All austenitic stainless steel fasteners are normally non-magnetic in the annealed condition; after cold working, some magnetic properties can be evident (see Annex H). <br>NOTE: The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows: ISO 3506-1: 2009 Mechanical properties of corrosion-resistant stainless steel fasteners-Part 1: Bolts, screws and studs (IDT) <br>The symbols which denote the degree of correspondence in the contents between the relevant International Standard and <strong>JIS</strong> are IDT (identical), MOD (modified), and NEQ (not equivalent) according to <strong>ISO/ lEC Guide 21-1.</strong>