D4042
Standard Test Method for Sampling and Testing for Ash and Total Iron in Steel Mill Dispersions of Rolling Oils
Organization:
Subject: total
Show full item record
contributor author | ASTM - ASTM International | |
date accessioned | 2020-06-14T19:45:19Z | |
date available | 2020-06-14T19:45:19Z | |
date issued | 2019 | |
identifier other | D4042.pdf | |
identifier uri | http://yse.yabesh.ir/std/handle/yse/275888 | |
description | D4042-93(2019) Standard Test Method for Sampling and Testing for Ash and Total Iron in Steel Mill Dispersions of Rolling Oils total iron~ steel mills~ separation~ rolling oils~ | |
title | D4042 | num |
title | Standard Test Method for Sampling and Testing for Ash and Total Iron in Steel Mill Dispersions of Rolling Oils | en |
type | Standard | |
status | Active Standard | |
tree | ASTM - ASTM International:;2019 | |
contenttype | Fulltext | |
subject keywords | total | |
subject keywords | iron | |
subject keywords | steel | |
subject keywords | mills | |
subject keywords | separation | |
subject keywords | rolling | |
subject keywords | oils | |
scope | 1. Scope
1.1 This test method describes a procedure for sampling and testing dispersions of rolling oils in water from operating steel rolling mills for determination of ash and total iron content. Its purpose is to provide a test method such that a representative sample may be taken and phenomenon such as iron separation, fat-emulsion separation, and so forth, do not contribute to analytical error in determination of ash and total iron. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Sections 6 and 7. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |