درباره ما
Browsing ECIA - Electronic Components Industry Association by Issue Date
Now showing items 1-20 of 507
-
ECA 215
Abstract: General;
The cable described by this standard consists of either two or three conductors of stranded, annealed, and tinned copper wire, insulated with synthetic or natural rubber, covered with a cotton ... -
ECA CB 2
Abstract: ABSTRACT
Contamination of printed wiring boards is defined, and examples are given of the causes of such contamination. The electrical effects of such contamination are then reviewed. Specifications are given ... -
ECA TEP 42
Abstract: INTRODUCTION
DEFINITION AND FUNCTION OF THE TUBE .
Magnetrons are defined as :* electron tubes "characterized by the interaction of electrons with the electric . field of circuit element in crossed ... -
ECA CB 4
Abstract: INTRODUCTION
For many years the question of the minimum wire size which could be safely used for wirewound resistors has been debated. In Military specifications the minimum wire diameter has been specified which ... -
ECA CB 5
Abstract: This test procedure provides standard methods for the evaluation of semiconductor thermal dissipators.
Purpose:
The purpose of this Bulletin is to establish standard procedures for the evaluation, calibration, ... -
ECA RS-162
Abstract: This standard describes the standard test procedures to be used for ceramic based printed circuits. It specifically covers the type A unit, but may be used as far as applicable for type B units, as defined below. Unit ... -
ECA CB 5-1
Abstract: The scope of this supplement to EIA Components Bulletin No. 5 is to present methods of instrumentation for plastic case semiconductors and integrated circuits for evaluation of thermal dissipating devices. -
ECA 356
Abstract: This standard shall cover definitions of terms that are generally referred to between manufacturers and users and shall define accepted nomenclature for commonly applied component and operating descriptions as related to ... -
ECA 331
Abstract: This Standard is intended to specify the jack and plug wiring for proper polarization and channel reproduction. It is also intended to specify phones marking for left and right when they are marked. This Standard covers ... -
ECA 339
Abstract: This method measures the susceptibility of magnetic tape to layer-to-layer adhesion between adjacent layers of a tape roll. This Standard was prepared because no other comparable industry- accepted document relating ... -
ECA 362
Abstract: These methods cover the determination of tensile yield force, tensile force at break, and tensile break elongation of magnetic tapes. This standard was prepared because no other comparable industry-accepted document relating ... -
ECA RS-399-A
Abstract: This standard covers the dimensional specifications considered essential for the successful interchange of cartridge called EIA Type CP-II (Compact Cassette) between equipment designed for audio recording and reproducing ... -
ECA RS-209-A
Abstract: INTRODUCTION
This Standard supersedes RS-209 and RS-209-1. It includes all items prepared by JEDEC Committee JT-8 on Mechanical Standardization, and approved by the Electronic Industries Association ... -
ECA 186-6E
Abstract: PURPOSE
These tests are intended to determine the ability of terminals to withstand the usual stresses which may be applied during assembly or disassembly operations. Several types of tests are provided ... -
ECA 186-8E
Abstract: PURPOSE
This sinusoidal high frequency vibration test is performed for the purpose of determining the effect on component parts of vibration in the frequency range of 10 to 500 Hz or 10 to 2000 Hz as ... -
ECA 186-2E
Abstract: PURPOSE
This test is intended to evaluate in an accelerated manner, the resistance of component parts to deterioration resulting from high humidity and heat conditions typical of tropical environments. ...