درباره ما
UFC - Unified Facilities Criteria: Recent submissions
Now showing items 141-160 of 255
-
UFC 3-230-14A
Abstract: This manual describes principles and procedures to be followed in formulating and conducting a water pollution prevention, control, and abatement program, and in planning facilities required for solution of water pollution ... -
UFC 3-260-01
Abstract: This manual prescribes dimensional and geometric layout criteria for safe standards for airfields, landing zones, heliports and helipads, and related permanent facilities, as well as the navigational airspace surrounding ... -
UFC 3-230-02
Abstract: MIL-HDBK-1164 provides general technical guidance for operating and maintaining potable water systems at fixed military installations. Since no two installations are exactly alike, this handbook is supplemental to site-specific ... -
UFC 3-220-02
Abstract: Descriptions of types of piles, advantages, disadvantages, and usage of piles, equipment, and installation methods are discussed in these instructions.
a. Equipment. Proper equipment and installation methods are critical ... -
UFC 4-179-01
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 3-190-04FA
Abstract: This manual covers roofing and waterproofing components and materials. Roofing components include deck, vapor retarder, insulation, membrane surfacing and flashing. Roofing materials include built-up, single-ply, modified ... -
UFC 3-210-06A
Abstract: Site planning is the art of evaluating a site, determining an appropriate program of activity and organizing that activity on the site. Site design is the art of arranging facilities on the site in support of the desired ... -
UFC 4-740-09AN
Abstract: Purpose
a. This guide contains design criteria for Army Arts and Crafts Centers which are in some instances referred to as Skill Development Centers. The term Skill Development Center will be used only when preparing ... -
UFC 3-570-02N
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 3-510-01 CHANGE 2
Abstract: This manual identifies the classes of electrical equipment that are sensitive to frequency and voltage variations. Appendix B covers identification of various low and medium voltage levels, along with the system frequencies, ... -
UFC 4-740-03
Abstract: SCOPE OF DOCUMENT.
This UFC provides guidelines for evaluating, planning, and designing Navy and Marine Corps Outdoor Adventure Centers (OAC), Rental Centers (RC), and Outdoor Center & Other Rentals ... -
UFC 4-730-03
Abstract: The standards established in this publication are applicable both within the Continental United States and outside the Continental United States Existing courier stations need not be modified to conform to construction ... -
UFC 3-250-03
Abstract: This manual prescribes materials, mix design procedures, and construction practices for flexible pavements.
PURPOSE.
This manual provides guidance for the preparation of drawings and specifications for road and ... -
UFC 4-711-01
Abstract: PURPOSE AND SCOPE
Purpose.
This UFC provides guidance for the design, construction, improvement, and repair of Department of Defense (DoD) family housing facilities in the United ... -
UFC 4-229-01N
Abstract: PURPOSE AND SCOPE.
This UFC is comprised of two sections. Chapter 1 introduces this UFC and provides a listing of references to other Tri-Service documents closely related to the subject. Appendix A ... -
UFC 4-212-01N CHANGE 4
Abstract: This UFC contains the basic criteria for the design and maintenance of Navy and Marine engine test facilities. Chapter 5 and 6 provide guidance for the testing of aircraft engine tie-downs. Note: Any engine restraint testing ... -
UFC 3-250-09FA
Abstract: This manual presents criteria for determining the thickness, material, and compaction requirements for all classes of aggregate surfaced roads and for Class I, II, and III airfields at US Army installations. Road classes ... -
UFC 3-410-04N
Abstract: This Unified Facilities Criteria (UFC) provides criteria for the design of ventilation systems that control contaminants generated from industrial processes.
PURPOSE OF CRITERIA.
Criteria are developed ... -
UFC 4-030-01
Abstract: This UFC applies to all new facility projects regardless of funding source, scope or method of accomplishment. The technical requirements recommended herein may not be applicable for projects outside the United States. ... -
UFC 3-401-01FA
Abstract: This manual provides design guidance for new UMCS, expansion of existing UMCS, upgrade of existing Energy Monitoring and Control Systems (EMCS) to UMCS, and expansion of existing EMCS. This manual includes guidance for ...