درباره ما
IEEE - The Institute of Electrical and Electronics Engineers, Inc.: Recent submissions
Now showing items 1701-1720 of 2832
-
IEEE 2600
Abstract: This standard defines security requirements (all aspects of security including but not limited to authentication, authorization, privacy, integrity, device management, physical security and information security) for ... -
IEEE 1415
Abstract: This guide provides maintenance testing and failure analysis guidance for form-wound, squirrel cage, induction machinery rated up to 15 kV. The guide addresses the following machine systems:
— Stator (winding and ...Subject(s) : failure analysis , induction machinery , induction motor , maintenance testing , maintenance tests , root cause analysis , -
IEEE 802.11
Abstract: The scope of this standard is to define one medium access control (MAC) and several physical layer (PHY) specifications for wireless connectivity for fixed, portable, and moving stations (STAs) within a local area. ...Subject(s) : 2.4 GHz , 3650 MHz , 4.9 GHz , 5 GHz , 5.9 GHz , advanced encryption standard , AES , carrier sense multiple access/collision avoidance , CCMP , channel switching , confidentiality , Counter mode with Cipher-block chaining Message authentication code Protocol , CSMA/CA , DFS , direct link , dynamic frequency selection , E911 , emergency alert system , emergency services , forwarding , generic advertisement service , high throughput , IEEE 802.11 , interface , international roaming , interworking , interworking with external networks , LAN , local area network , MAC , measurement , media-independent handover , medium access control , medium access controller , mesh , MIH , MIMO , MIMO-OFDM , multi-hop , multiple input multiple output , network advertisement , network discovery , network management , network selection , off-channel direct link , path-selection , PHY , physical layer , power saving , QoS , QoS mapping , quality of service , radio , radio frequency , radio management , radio resource , RF , SSP , SSPN , subscriber service provider , temporal key integrity protocol , TKIP , TPC , transmit power control , tunneled direct link setup , wireless access in vehicular environments , wireless LAN , wireless local area network , wireless network management , WLAN , zero-knowledge proof , -
IEEE C37.101
Abstract: This guide has been prepared to aid in the application of relays and relaying schemes for protection against stator ground faults on high-impedance grounded generators. The guide is not intended for the selection of generator ... -
IEEE C135.35
Abstract: This standard covers several types and sizes of cable racks and cable rack hooks that are used to support current carrying cables in underground manholes, vaults, and tunnels. -
IEEE 14764 ERTA
Abstract: This standard describes an iterative process for managing and executing software maintenance activities. Use of this standard is not restricted by size, complexity, criticality, or application of the software product. This ... -
IEEE 762
Abstract: (This Foreword is not a part of ANSI/IEEE Std 762-1987, IEEE Standard Definitions for Use in Reporting Electric Generating Unit Reliability, Availability, and Productivity.)
Measures of generating unit performance have ... -
IEEE 1450.2
Abstract: FOREWORD
Standard Test Interface Language (STIL) (IEEE Std 1450-1999) was developed and approved with an intentionally constrained scope. While DC levels were explicitly excluded from that scope, it was ... -
IEEE 980
Abstract: This guide discusses the significance of oil-spillage regulations and their applicability to electric supply substations; identifies the sources of oil spills; discusses typical designs and methods for dealing with oil ...Subject(s) : collecting pit , oil discharge , oil spill , oil-containment methods , oil-containment system , primary oil containment , retention pit , secondary oil containment , spill prevention control and countermeasures (SPCC)plan , -
IEEE 802.21B
Abstract: General
Change the list in 1.3 as follows:
The following items are not within the scope of this standard:
— Intra-technology handover [except for handovers across extended ... -
IEEE C37.90.2
Abstract: This standard defines a required withstand level and establishes a test method to evaluate the susceptibility of protective relays to single-frequency electromagnetic fields in the radio frequency domain, such as those ...Subject(s) : field strength , keying test , Radiated Electromagnetic Interference , relay , relay systems , step test , sweep test , transceivers , -
IEEE C37.302
Abstract: This guide describes the testing of fault current limiters (FCLs) operating on condition-based impedance increase for AC systems 1000 V and above. This guide does not include constant impedance series reactors and single ... -
IEEE C37.59 ERTA
Abstract: Present industry conversions involve low- and medium-voltage power circuit breakers used in metal-enclosed and metal-clad switchgear; low- and medium-voltage fused contactors; switchgear vertical sections; power fuse ...Subject(s) : conversion , power switchgear equipment , qualified design , -
IEEE 1800
Abstract: This standard provides the definition of the language syntax and semantics for the IEEE 1800™ SystemVerilog language, which is a unified hardware design, specification, and verification language. The standard includes ... -
IEEE C57.12.40
Abstract: This standard covers certain electrical, dimensional, and mechanical characteristics and takes into consideration certain safety features of three-phase, 60-Hz, liquid-immersed, self-cooled, network transformers with a ...Subject(s) : copper-bearing steel , grounding switch , magnetizing switch , network , subway , transformer , vault , -
IEEE 80
Abstract: This guide is primarily concerned with outdoor ac substations, either conventional or gas-insulated. Distribution, transmission, and generating plant substations are included. With proper caution, the methods described ...Subject(s) : ground grids , grounding , substation design , substation grounding , -
IEEE C135.22
Abstract: This standard covers ferrous pole-top insulator pins with 1-inch- and 1-3/8-inch-diameter lead threads used in overhead line construction. -
IEEE 1149.8.1
Abstract: This standard specifies extensions to IEEE Std 1149.1™ that define the boundary-scan structures and methods required to facilitate boundary-scan-based stimulus of interconnections to passive and/or active ...