درباره ما
AASHTO - American Association of State Highway and Transportation Officials: Recent submissions
Now showing items 1501-1520 of 2524
-
AASHTO M 43
Abstract: This specification defines aggregate size designations and ranges in mechanical analyses for standard sizes of coarse aggregate and screenings for use in the construction and maintenance of various types of highways and ...Subject(s) : classification , Coarse aggregate , standard sizes , -
AASHTO HB-17 DIVISION II SEC 15
Abstract: DESCRIPTION: Concrete block and brick mansonry shall consist of concrete blocks or brick laid in cement mortar and may be unreinforced or reinforced with steel reinforcing. Block or brick pavements are not included under ... -
AASHTO M 153
Abstract: This specification covers preformed expansion joint fillers of the following four types for use in concrete, brick, or stone construction:
Type I—sponge rubber,
Type II—cork,
Type ...Subject(s) : Construction , cork , expansion , joint , paving , preformed , rubber , sponge , structural , -
AASHTO R 11
Abstract: This practice is intended to assist the various technical committees in the use of uniform methods of indicating the number of digits which are to be considered significant in specification limits, for example, specified ... -
AASHTO TP 96
Abstract: This method covers test methods and selection criteria for prequalification of sealers for protecting new concrete or prolonging the life of sound in-service concrete used in highway structures. Sealer testing and evaluation ... -
AASHTO T 97
Abstract: This test method covers determination of the flexural strength of concrete by the use of a simple beam with third-point loading.
The values stated in SI units are to be regarded as the standard.
Note ... -
AASHTO ARRA
Abstract: INTRODUCTION
The Untold Transportation Success Stories of Economic Recovery
There are many ways to measure the success of transportation spending under the economic recovery program. ... -
AASHTO GSDPB
Abstract: These Guide Specifications address the design and construction of typical pedestrian bridges which are designed for and intended to carry primarily pedestrians, bicyclists, equestrian riders, and light maintenance vehicles, ... -
AASHTO R 65
Abstract: This practice is to provide a general evaluation framework for assessing the feasibility to use recycled materials in the highway environment.
This document was developed using the Framework for Evaluating Use of ... -
AASHTO T 346
Abstract: The procedures for testing glass beads used in traffic markings are described in this method. This includes the method for obtaining a representative test sample, preparation of the test specimens, and performing the ... -
AASHTO M 203M/M 203
Abstract: This specification covers two types and two grades of steel strand, uncoated seven-wire for use in pretensioned and posttensioned prestressed concrete construction. The two types of strand are lowrelaxation and stress-relieved ...