درباره ما
AASHTO - American Association of State Highway and Transportation Officials: Recent submissions
Now showing items 2041-2060 of 2524
-
AASHTO T 111
Abstract: This method of test is intended for the determination of mineral matter in solid, semisolid, or liquid asphalt.
The values stated in SI units are to be regarded as the standard.
This standard does not purport ... -
AASHTO T 351
Abstract: This test method covers determination of the visual stability index of self-consolidating concrete (SCC), both in the laboratory and in the field. SCC is defined as a highly workable concrete that can flow through densely ... -
AASHTO T 335
Abstract: This test method covers the determination of the percentage, by mass, of a coarse aggregate sample that consists of fractured particles meeting specified requirements.
This standard may involve hazardous materials, ... -
AASHTO LRFDCONS
Abstract: FOREWORD
The first broadly recognized national standard to design and construct bridges in the United States was published in 1931 by the American Association of State Highway Officials (AASHO), the ... -
AASHTO MP 24
Abstract: This specification covers fast-drying waterborne traffic line paints for use on asphalt and cement concrete pavements. Waterborne traffic lines applied to roadways shall be installed using glass spheres or other optics by ... -
AASHTO T 85
Abstract: This method covers the determination of specific gravity and absorption of coarse aggregate. The specific gravity may be expressed as bulk specific gravity, bulk specific gravity (saturated surface-dry (SSD)), or apparent ... -
AASHTO TP 115
Abstract: This test method covers the determination of the tack coat adhesion quality as measured by the tensile strength of tack coat materials on the free surface of asphalt pavement in the field or laboratory.
This test can ... -
AASHTO HAZ-1
Abstract: Foreword
In the days, months, and years following the events of September 11, AASHTO and its partners united through the Transportation Research Board to improve and enhance the skills of the transportation ... -
AASHTO M 85
Abstract: This specification covers ten types of portland cement as follows (see Note 1):
Type I—For use when the special properties specified for any other type are not required;
Type IA—Air-entraining cement ... -
AASHTO M 292M/M 292
Abstract: This specification covers a variety of carbon, alloy, and martensitic stainless steel nuts in the size range M6 through M100 [¼ through 4 in.] nominal. It also covers austenitic stainless steel nuts in the size range ... -
AASHTO PP 73
Abstract: This practice covers procedures and test methods for quality assurance testing and job site quality control for protective sealers for protecting new concrete or prolonging the life of sound, inservice concrete used in ... -
AASHTO T 243M/T 243
Abstract: This specification establishes the procedure for longitudinal Charpy V-notch testing of structural steel and contains two frequencies of testing. The impact properties of steel can vary within the same heat and piece, be ...Subject(s) : Charpy V-notch , impact , sampling procedure , steel , structural steel , testing ,