Abstract: This test procedure establishes a test method to determine whether accessory thread strength and portion of the connector that accepts cable clamps and "J" adaptors shall be capable of withstanding torque requirements ...

Abstract: PURPOSE
This test is performed to determine the effect of storing or operating component parts at elevated temperatures for various time periods. Different degrees of severity as prescribed by temperature ...

Abstract: This document has been compiled in response to a generally expressed desire on the part of both users and manufacturers for a guide to the use of quartz crystal units for frequency control so that they may be used to their ...

Abstract: This guide is intended to supplement EU-512, "Standard Methods of Measurement of Equivalent Electrical Parameters of Quartz Crystal Units, 1 kHz to 1 gHz." Frequent mention of the standard is made, and having the standard ...

Abstract: This standard defines a test for solderability of solid lead wires, terminals, and conductive accessories of component parts which are to be joined b a soldering operation involving the use of rosin type flux and solder ...

Abstract: This standard covers requirements for Assembly Component Trays –ACTs used during automated assembly processes. The standard size is covered which works with tray slots handling an envelope of 298.45mm (11.75inches) ...

Abstract: PURPOSE
This sinusoidal high frequency vibration test is performed for the purpose of determining the effect on component parts of vibration in the frequency range of 10 to 500 Hz or 10 to 2000 Hz as ...

Abstract: This Standard establishes uniform methods for testing electronic component parts. In case of conflict between this Standard and any individual component standards or detail specifications, the requirements of the individual ...

Abstract: PURPOSE
This test is conducted for the purpose of determining the resistance of a component part to exposures at ! extremes of high and low temperatures in air, and to the shock of alternate exposures ...

Abstract: PURPOSE
This test is to measure the resistance offered by the insulating members of a component part to an impressed direct voltage tending to produce a leakage of current through or on the surface of ...