درباره ما
ASTM - ASTM International: Recent submissions
Now showing items 2281-2300 of 39933
-
Standard Practice for Mat Bond Evaluation of Performance and Compatibility for Resilient Flooring System Components Prior to Installation
Abstract: 5.1 Any individual performing a mat bond evaluation should either be a qualified installer or a trained and experienced evaluator of resilient flooring and adhesive bond strength. 5.2 This practice should not be considered ... -
Standard Specification for Design and Construction of Lightweight Unmanned Aircraft Systems (UAS)
Abstract: This specification establishes the airworthiness requirements for the design of fixed-wing unmanned aircraft systems. It defines the baseline design, construction, and verification requirements for an unmanned aircraft ... -
Standard Specification for Normal Category Aeroplanes Certification
Abstract: This specification covers industry standards which have been determined by consensus to demonstrate compliance to the requirements ("the Rules") for Level 1, 2, 3, 4 Normal Category Aeroplanes. It includes only standards ... -
Standard Test Method for Ballistic-Resistant Security Glazing Materials
Abstract: 5.1 This test method provides a basis for the comparative evaluation of the ballistic resistance of security glazing and should not be used to establish or confirm the absolute prevention of damage, harm, or injuries from ... -
Standard Test Method for Fastener Rupture and Tear Resistance of Roofing and Waterproofing Sheets, Roll Roofing, and Shingles
Abstract: 4.1 Test values for the resistance of specific ply sheets, roll roofing, or shingles to selected fastener pull-through may assist in the determination of appropriate fastener spacing. The relative behavior of different ... -
Standard Specification for Crosslinked Polyethylene (PEX) Tubing with Oxygen Barrier for Hot- and Cold-Water Hydronic Distribution Systems
Abstract: This specification covers the requirements, test methods, and markings for crosslinked polyethylene (PEX) tubing with a polymeric oxygen barrier layer, made in one standard dimension ratio (SDR 9), and distribution system ... -
Standard Specification for Electrical Systems for Aircraft with Combustion Engine Electrical Power Generation
Abstract: This specification applies to the electrical systems aspects of airworthiness and design for "small" aircraft. It establishes the Aircraft Type Code (ATC) compliance matrix based on airworthiness level, number of engines, ... -
Standard Specification for 3 in. to 30 in. (75 mm to 750 mm) Polypropylene (PP) Corrugated Single Wall Pipe and Fittings
Abstract: This specification covers the general requirements and test methods for materials, dimensions, workmanship, elongation, brittleness, pipe stiffness, and markings for single wall corrugated polypropylene (PP) pipe and ... -
Standard Specification for Treestands, Climbing Sticks, and Tripod or Tower Stands
Abstract: This specification establishes the requirements for treestands, climbing sticks, and tripod/tower stands that are used for hunting, photographing, or general observation. It covers ladder treestands; non-climbing, fixed ... -
Standard Guide for Autologous Platelet-Rich Plasma for Use in Tissue Engineering and Cell Therapy
Abstract: 4.1 Autologous PRP and platelet gels are utilized in a wide range of orthopedic, sports medicine, regenerative medicine, and surgical applications (3-5). PRP and platelet gels are layered, sprayed, injected, molded, or ... -
Standard Specification for Adult Portable Bed Rails and Related Products
Abstract: This safety specification establishes the performance requirements for adult portable bed rails, related products, and adult portable bedrail accessories, including requirements for resistance to entrapment, marking and ...