درباره ما
AASHTO T 164
Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA)
Year: 2014
Abstract: These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA) and HMA pavement samples. Aggregate obtained by these methods may be used for sieve analysis using T 30.
The values stated in SI units are to be regarded as the standard.
This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 8.
Note 1—The results obtained by these methods may be affected by the age of the material tested, with older samples tending to yield slightly lower asphalt binder contents. Best quantitative results are obtained when the test is made on HMA mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt binder when some aggregates are used; some solvent may remain within the mineral matter affecting the measured asphalt binder content.
The values stated in SI units are to be regarded as the standard.
This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 8.
Note 1—The results obtained by these methods may be affected by the age of the material tested, with older samples tending to yield slightly lower asphalt binder contents. Best quantitative results are obtained when the test is made on HMA mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt binder when some aggregates are used; some solvent may remain within the mineral matter affecting the measured asphalt binder content.
Show full item record
| contributor author | AASHTO - American Association of State Highway and Transportation Officials | |
| date accessioned | 2017-09-04T17:46:06Z | |
| date available | 2017-09-04T17:46:06Z | |
| date copyright | 2014.01.01 | |
| date issued | 2014 | |
| identifier other | EKYLIFAAAAAAAAAA.pdf | |
| identifier uri | https://yse.yabesh.ir/std/handle/yse/169262 | |
| description abstract | These methods cover the quantitative determination of asphalt binder in hot mix asphalt (HMA) and HMA pavement samples. Aggregate obtained by these methods may be used for sieve analysis using T 30. The values stated in SI units are to be regarded as the standard. This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 8. Note 1—The results obtained by these methods may be affected by the age of the material tested, with older samples tending to yield slightly lower asphalt binder contents. Best quantitative results are obtained when the test is made on HMA mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt binder when some aggregates are used; some solvent may remain within the mineral matter affecting the measured asphalt binder content. | |
| language | English | |
| title | AASHTO T 164 | num |
| title | Standard Method of Test for Quantitative Extraction of Asphalt Binder from Hot Mix Asphalt (HMA) | en |
| type | standard | |
| page | 22 | |
| status | Active | |
| tree | AASHTO - American Association of State Highway and Transportation Officials:;2014 | |
| contenttype | fulltext |