درباره ما
ARMY - AR - US Army Research Devlp & Engr Command, Armament Research Devlp & Engr Center: Recent submissions
Now showing items 1741-1760 of 2057
-
MIL-HDBK-138B
Abstract: This handbook applies to the selection of any commercially owned or military owned intermodal container meeting the standards of the International Organization for Standardization (ISO) and certified under the provisions ...Subject(s) : Anti-rack Hardware , Bottom End Rail , Bottom Side Rail , Corner Fitting , Corner Post , Cross Member , CSC , Door Header , Door Sill , Flooring , Forklift Pocket , Forklift Pocket Strap , Front End Frame , Gooseneck Tunnel , IMDG , ISO , Load Bearing Surface , Mechanical Restraint System , MILVAN , Non IMDG , Rear End Frame , Reinspection Decals , Top End Rail , Top Side Rail , Understructure , -
MIL-W-12133/9
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
The requirements for acquiring the washers described herein shall consist of this specification and the latest issue ... -
MIL-C-40084C
Abstract: This specification covers a fire-resistant, water-emulsifiable, oil type corrosion preventative compound to be used as a rust inhibiting coating. Intended Use: The water emulsifiable corrosion preventive ...Subject(s) : Coating , Corrosion , Rust Inhibiting , -
MIL-S-13261G
Abstract: This specification covers the parts and the loading, assembling and packing of three signals of different colors, designated as Signal, Green Star Cluster, M125A1: Signal Red Star Cluster, M158; and Signal, White Star ... -
MIL-P-157A
Abstract: This specification covers one type of onionskin paper for use in ammunition items (see 6.1). Intended Use: The onionskin paper covered by this document is primarily intended for use in ammunition items ... -
MIL-F-70673
Abstract: This specification covers the quality assurance provisions and special requirements not covered by the drawings for one type of fuze designated as Fuze, Rocket, Base Detonating, M442. Intended Use: The ...Subject(s) : Fuze , Military specification , Rocket (2.75 Inch) , Warhead , Flare , -
MIL-D-20505D
Abstract: This specification contains requirements not covered by the drawings and provides quality assurance provisions for the fabrication of parts, assembly and packing for M80 Explosive Detonation Simulator. Intended ... -
MIL-W-71094
Abstract: This specification covers the requirements and quality acceptance provisions for coal-based waxes, Type I and Type II (see 6.1.1) for the manufacture of explosive compositions. Intended Use: The waxes ...Subject(s) : Coal-based waxes , Explosive desensitizing waxes , Montan waxes , RDX ,