ECIA - Electronic Components Industry Association: Recent submissions
Now showing items 181-200 of 507
-
ECA 436
Abstract: This standard applies to circuit board mounted relays that utilize magnetically actuated dry reed switches to perform the switching function. This document is intended to help standardize dry reed relay packaging, testing, ... -
ECA EIA-364-101
Abstract: This standard is applicable to electrical connectors, sockets, cable assemblies or interconnection systems. -
ECA 337
Abstract: This specification covers glass coated thermistor beads and thermistor beads in glass probes and glass rods. -
ECA EIA-448-3-A
Abstract: PURPOSE
The purpose of this test method is to determine if the lens colors fall within specified limits. -
ECA EIA/ECA-364-50B
Abstract: This standard establishes a method to ascertain the ability of fully wired connector assemblies to resist the effects of dry dust (fine sand) laden atmosphere. -
ECA EIA-364-96
Abstract: This test method applies to compliant pins inserted in printed circuit boards with plated-throughholes (PTH). -
ECA EIA-364-98
Abstract: Introduction
This specification describes a test procedure for determining the mechanical retention strength of the locking retention features of mated plastic connector housings. -
ECA 540A000-A
Abstract: This Sectional Specification relates to the sockets for chip carriers of assessed quality. The purpose of this Specification is to provide a means of assuring interchangeability between devices and compatibility between ... -
ECA 550
Abstract: GENERAL
Type FD plugs when mated with Type FD jacks must meet the ratings and characteristics. Type FD jacks, once mated with non-Type FD connectors (e.g., Type F connectors), may not meet the ratings and characteristics ... -
ECA TEP 42
Abstract: INTRODUCTION
DEFINITION AND FUNCTION OF THE TUBE .
Magnetrons are defined as :* electron tubes "characterized by the interaction of electrons with the electric . field of circuit element in crossed ... -
ECA CB-12
Abstract: The purpose of this study is to evaluate the performance characteristics of gold plating thicknesses when exposed to a severe series of environmental sequences. phenomenon which could potentially cause contact interface ... -
ECA 186-7E
Abstract: PURPOSE
This vibration fatigue test is performed for the purpose of determining the ability of component parts and their mountings to withstand vibration in the low frequency range of 10 to 55 Hertz. ... -
ECA EIA-540FAAD
Abstract: The Multi-Package Module Sockets of assessed quality covered by this Detail Specification shall have:
a) Maximum enclosure dimensions (See Figure 1.)
b) Working voltage not to exceed 250 volts (rms).
c) Current ... -
ECA 520AAAC
Abstract: The illuminated and non-illuminated pushbutton switches of certified quality covered by this specification shall:
(a) Mount in a panel hole of 15.88 mm (.625 in.) sq.
(b) Have a maximum rated voltage of 125 Vac ... -
ECA EIA-364-85
Abstract: The purpose of this procedure is to determine the presence of mechanical damage, wear-through, and other gross defects in the contact finish. Most contact finishes are intended to be protective, and the presence of gross ... -
ECA EIA-503-A
Abstract: This test method applies to the measurement of x-radiation emitted from direct-view television picture tubes.
PURPOSE
The purpose of this Standard is to obtain x-radiation characteristics of ...