درباره ما
NAVY - AS - Naval Air Systems Command: Recent submissions
Now showing items 1221-1240 of 2147
-
MIL-DTL-81581/2B
Abstract: This specification sheet covers the detail requirements for high pressure, breathing oxygen hose assemblies with connections for integrated communication systems.Intended Use: The hose assemblies covered by ... -
MIL-L-19701B
Abstract: This specification covers the requirements for a semi-fluid lubricant intended for the lubrication of aircraft machine guns and accessory equipment between −55°C and 70°C and under cold-sweat-cold cycling ... -
MIL-DTL-85052/1C VALID NOTICE 1
Abstract: Intended Use: These clamps are intended for use as follows:Temperature range: - 65 to + 275 °F (for higher temperature rated clamps, see MIL-DTL-85052/3).
Systems: 1. All aromatic ...
-
MIL-H-85800
Abstract: This specification defines the requirements for polytetrafluoroethylene (PTFE) lined, aramid fiber reinforced, hose assemblies with dynamic beam seal end fittings for use in aerospace fluid systems. Intended ...Subject(s) : (a) Hose assemblies , (b) Polytetrafluoroethylene , (c) Aramid fiber , (d) Dynamic beam seal , (e) Aerospace fluid systems , (f) 5000/8000 psi operating pressure , -
MIL-STD-2223 CHG NOTICE 1
Abstract: Applicability. This standard establishes test methods for insulated single conductor electric wires made with tin-coated, silver-coated or nickel-coated conductors of copper or copper alloy.Subject(s) : Circumferential , Insulation , Mandrels , Sample , Thermal , Typical , Wicking , -
MIL-DTL-7793G
Abstract: This specification covers the general requirements for hermetically sealed, time totalizing meters.Intended Use: The time totalizing meters covered by this specification are intended for use in equipment where ... -
TT-T-2935
Abstract: This specification covers the requirements for a low vapor pressure thinner for purging and cleaning high solids epoxy and polyurethane coatings from application equipment. Intended Use: The low vapor pressure ...Subject(s) : Prepaint , Preseal , Solvent , -
MIL-C-29600/10
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense.
The complete requirements for acquiring the connectors described herein shall consist of this specification and the ... -
MIL-G-85103B
Abstract: This specification establishes the performance design, manufacture, tests and acceptance requirements for the 25mm gun system, referred to herein as the gun system. Intended Use: The gun system is intended ... -
MIL-N-23407B
Abstract: The equipment covered by this specification shall measure the ground velocity of fixed wing aircraft in flight.
The Navigation Set, Radar shall consist of the following items:...
-
W-L-101/95B
Abstract: This specification sheet was approved by the Commissioner, Federal Supply Service, General Services Administration, for the use of all Federal agencies.
(This specification sheet forms a part of the latest issue of ... -
MIL-E-85082/7
Abstract: This specification is approved for use by all Departments and Agencies of the Department of Defense. The requirements for acquiring the Encoders, Shaft Angle to Digital, described herein shall consist of this specification ... -
MIL-T-85244
Abstract: This specification establishes the requirements for the manufacture and acceptance of the Telemetric Data Transmitting Set AN/DKT-49 (XN-1), AN/DKT-49(XN-2), and AN/DKT-49A, herein referred to as the "assembly."
Assemblies ...