درباره ما
ECIA - Electronic Components Industry Association: Recent submissions
Now showing items 361-380 of 507
-
ECA EIA-364-113
Abstract: This test procedure establishes a test method to determine whether corrosion products as a result of residual corrosive elements may be created on contact surfaces. Said products may be a result from improper cleaning or ... -
ECA 386
Abstract: The purpose of this standard is to describe a method of phonograph rumble measurement for purposes of correlation and specification of phonograph rumble level on a laboratory basis. The measurement reflects the electrical ... -
ECA EIA-364-62A
Abstract: This standard establishes test methods to determine the ability of the terminals of an electrical connector to withstand the mechanical stresses likely to be applied during normal assembly operations. This test method is ... -
ECA EIA/ECA-364-18B
Abstract: This standard establishes guidelines for visual and dimensional inspection of electrical connectors and sockets prior to, during, and after other test procedures. -
ECA TEP 171
Abstract: This test method applies to the measurement of unwanted radio frequency energy emitted from electron tubes designed to operate in the microwave region of 100 MHZ to 30 GHZ. It is assumed that the ... -
-
ECA EIA/ECA-797
Abstract: Overview
Except for a few surface-mount technology (SMT) aluminum electrolytic capacitor types with solid electrolyte systems an aluminum electrolytic capacitor consists of a wound capacitor element, ... -
ECA IS-722
Abstract: Description
This specification defines the qualification program for low voltage, supplemental fuses. Fuses covered will be limited to axial-leaded, radial-leaded and surface mount configurations having ... -
ECA EIA-970
Abstract: This test method is used to measure the S parameters of low-inductance multilayer ceramic capacitors when mounted in shunt on a probeable low inductance test fixture. -
ECA TEP 181
Abstract: This test method applies to the measurement of incidental X-radiation emitted from power tubes.
Purpose To obtain the X-radiation characteristics of power tubes in order to determine the levels emitted by the ... -
ECA EIA-763
Abstract: This standard covers requirements for punched and embossed carrier taping of components such as silicon dies, bumped flip chip devices, and chip scale packages. Refer to EIA 48 1-1 for current industry standard for 8 mm ... -
ECA TEP131 (COLOR)
Abstract: This publication provides the criteria of color television picture tube parts and safety panels. Other television picture tube parts are being produced, new parts undoubtedly will be produced after this is issued, and the ... -
ECA 362
Abstract: These methods cover the determination of tensile yield force, tensile force at break, and tensile break elongation of magnetic tapes. This standard was prepared because no other comparable industry-accepted document relating ... -
ECA 186-9E
Abstract: This standard defines a test for solderability of solid lead wires, terminals, and conductive accessories of component parts which are to be joined by a soldering operation involving the use of rosin type flux and solder ... -
ECA EIA-364-33A
Abstract: This procedure applies to connectors, mated pin-and-socket assemblies and individual contacts or printed-circuit-board (PCB) connector sockets.