درباره ما
ECIA - Electronic Components Industry Association: Recent submissions
Now showing items 41-60 of 507
-
ECA TEP 137
Abstract: INTRODUCTION
NEED FOR A RATING SYSTEM
The conditions under which an electron tube may be operated are limited by fundamental capabilities of' the tube itself. Physical limitations exist, for example, ... -
ECA EIA-700BAAE
Abstract: This standard applies to rectangular cable to board connectors having the following characteristics:
• shielded;
• 4 to 20 positions;
• rectangular-shaped mating interface; ... -
ECA 498A000
Abstract: This Sectional Specification covers alphanumeric keyboards having full stroke or short stroke key travel and intended for use in information handling systems by a trained operator. Both product qualification and capability ... -
ECA EIA-540CAAD-A
Abstract: The relay sockets, of assessed quality, covered by this detail specification have:
a) The ability to mate with a DPDT 5 ampere-rated , hermetically sealed relay.
b) A rated voltage not to exceed, 250 volts. (rms) ... -
ECA EIA-948
Abstract: This Standard covers requirements for component trays used during automated handling. -
ECA EIA-364-44A
Abstract: The object of this test is to detail a standard test method to determine the ability of an electrical connector to operate with an acceptable level of partial discharge at working voltages up to the extinction voltage. -
ECA EIA-364-36B
Abstract: This procedure is to determine the integrity of contacting surfaces (at the mating and/or termination areas) by assessment of the gas tight characteristics of the contacting surfaces. The gas tight characteristic simulates ... -
ECA 700AAAB
Abstract: This standard is applicable to high density, modular two-part connectors, designed for use with printed mezzanine cards that are intended to be installed parallel to host printed boards. The resultant stack height between ... -
ECA EIA-540ACAA
Abstract: The Chip Carrier Sockets of assessed quality covered by this detail specification shall have:
a) Maximum enclosure dimensions that include cover and latching hardware as illustrated in Figure 1.
b) A working voltage ... -
ECA EIA-364-46C
Abstract: This procedure is to define a method of detecting a discontinuity of one microsecond or longer in a mated electrical connector, contact or socket. This procedure shall not be used for durations less than one microsecond; ... -
ECA EIA-800
Abstract: Introduction
This guideline is intended to facilitate a common industry direction with regard to IPD chipscale packaging. This guideline is not intended to document special product designs that are ... -
ECA EIA-448-19A
Abstract: PURPOSE
The purpose of this standard is to evaluate electromechanical surface mountable components that have been subjected to the environmental effects of machine soldering using the batch type vapor phase ... -
ECA 322
Abstract: This EIA Standard covers linear-wound variable resistors used as rheostats and as potentiometers (variable voltage-dividers) , having a resistance element of wire, wound on an isulating form shaped in an arc, so that a ... -
ECA EIA-364-109
Abstract: This procedure applies to interconnect assemblies, such as electrical connectors and sockets.
Object
This standard describes a test method to measure the loop inductance (1 nH – 10 nH range) in the frequency ... -
ECA EIA-520E000-A
Abstract: This sectional specification relates to in-line switches of certified quality. Switches covered by this specification are intended for direct assembly to printed circuit boards (soldered in) for use as an interface with ... -
ECA TEP194
Abstract: INTRODUCTION
Since the advent of commercial television, the picture tube operating anode voltage in TV receivers has been increased from time to time, requiring that more and more X-radiation shielding be provided ... -
ECA 535BAAC-A
Abstract: This document was developed under the cognizance of the P-2.5 Subcommittee on Electrolytic Dielectric Capacitors.